FlexMotion

FlexMotion 1D Start

Start a single axis move.

FlexMotion 3D Goto

Start a move to a specified position in 3D.

FlexMotion 3D Start

Start a move to a specified position in 3D.

FlexMotion Axis to ADC

Map an axis number to a corresponding analog input number.

FlexMotion Initialize Outputs

Set FlexMotion breakpoint outputs in preparation for a transition.

FlexMotion Initialize Popup

Wrapper for initialize controller that pops up a status window.

FlexMotion Load Trigger

Define a trigger program that pulses for 1ms at specified spatial intervals.

FlexMotion Run Master Program

Define a program that will signal over the RTSI bus when it is starting. Slave programs can use the signal to start as well.

FlexMotion Run Slave Program

Define a program that will look for a RTSI line to start motion. RTSI line is mapped to a trigger input that this program waits on, and axis map is set by a variable. Useful for synchronizing motion start on multiple boards.

FlexMotion Write Buffer or Simulate

Writes data to a previously configured buffer.